Installation Instructions

INSTALLATION:
STEP 1: Requires: Mounng Backplate, Screwdriver, and Level
Use a stud nder (not included) to nd studs in desired mounng area. Place mounng backplate against wall in the
desired posion. Use a level (not included) to ensure the mounng backplate is level, then mark holes with a pencil (not
included). Note: For proper installaon, ensure the arrow on mounng backplate is facing upward. See Figure 1.
Note: If the shelf is not being aached to a stud you will need to insert plasc anchors using a drill with 7/32” drill bit to
make the hole.
STEP 2: Requires: Mounng Backplate, Screwdriver, Plasc Anchors (if no stud) and Installaon Screws
Use a screwdriver (not included) to mount the backplate ush against the wall with the installaon screws. If not installing
directly into studs, ensure the installaon screws are installed using the plasc anchors. See Figure 2.
STEP 3: Requires: Set Screws, Shelf, Level, and Mounng Backplate
Slide shelf onto mounng backplate. Use level to ensure the shelf is level, then align holes on the boom of the shelf with
the holes on tubes of mounng backplate. Insert set screws through holes unl shelf is secured to mounng backplate. See
Figure 3.
Tools Required (not included):
- Level
- Pencil
- Screwdriver
- Drill
- 7/32” Drill Bit
Installaon Materials (included):
- 1 Shelf
- 1 Mounng Backplate
- 10 Installaon Screws 1.4” long
- 10 Plasc Anchors
- 2 Set Screws 0.8”
Please read this manual carefully before
beginning assembly of this product. Check that
all components are included. Keep this manual
for future reference.
Figure 1
Figure 2
PVC Veneer Floang Shelf
Assembly Instrucons
weight capacity 17 lb / 7.7 kg
Figure 3
Only needed if not
hanging on a stud