Installation Instructions

Fir Wood Floang Shelf
Assembly Instrucons
weight capacity 17.6 lb / 8 kg
Tools Required (not included):
- Level
- Pencil
- Cross-head Screwdriver
- Drill
- 7/32” Drill Bit
Installaon Materials (included):
- 1 Shelf
- 2 Installaon Screws 1.5” long
- 2 Plasc Anchors
Please read this manual carefully before
beginning assembly of this product. Check that
all components are included. Keep this manual
for future reference.
Figure 1 Figure 2 Figure 3
INSTALLATION:
STEP 1: Requires: Screwdriver, and Level
Use shelf as a guide to mark where screws will be secured to the wall. Note: You may opt to use a level (not included) to
verify the markings are straight. See Figure 1.
Note: If the shelf is not being aached to a stud you will need to insert plasc anchors using a drill with 7/32” drill bit to
make the hole.
STEP 2: Requires: Power Drill and 3/32” Bit, Cross-head Screwdriver, Shelf, Plasc Anchors (if no stud) and Installaon Screws
Use the power drill and 3/32” drill bit to drill hole at mark. Use the power drill with a cross-head bit or cross-head
screwdriver to drive the installaon screw into a stud or anchor. Leave a 1/8” gap between the screwhead and the wall.
Note: If you are drilling into a wall where no studs are available, use the plasc anchors to secure screws. See Figure 2.
STEP 3: Requires: Installaon Screws and Shelf
Slide shelf down onto mounng screws unl screw heads t snugly into keyholes. If unit is not ush to the wall aer
installaon, remove shelf, ghten mounng screws slightly and re-install. Repeat as needed. See Figure 3.
Only needed if not
hanging on a stud