Installation Instructions

3
HELPFUL HINTS
Unfinished edges are shaded in gray. It is important to understand how finished edges go together. Take a moment to lay out all the wood pieces and note the
finished and unfinished (raw wood) edges. Arrange pieces so all finished edges are facing the same way. While assembling, take care to note in each diagram
which way finished edges are facing. In general, all finished edges will face forward and all finished sides (large area of piece) will face up when product is
fully assembled and upright.
HAND TIGHTEN SCREWS
We recommend you hand-tighten screws. Use care not to overtighten if using power tools.
finished edge
unfinished edge
We recommend you protect your work surface during assembly to prevent scratching or damage to table tops, wood oors, etc.