2-Cube Organizer Assembly Instructions 3643 / 3644 / 3645 Tools Needed: 01- 3661 7/17
SAFETY PRECAUTIONS WARNING • This unit contains small parts which could be a choking hazard for small children. Children should be under adult supervision at all times or serious injury could occur. • Always unload unit prior to moving the unit. The weight of personal belongings can cause the unit to become unstable and either tip or collapse. Serious bodily injury and/or damage to personal belongings may occur. • Do not overload unit.
HARDWARE (H1) x 4 dowel DESCRIPTION (H2) x 8 hex screw QUANTITY A side panel 2 B top and bottom panel 2 C divider 1 B (H3) x 2 L-bracket screw #10 x 1/2” (H4) x 2 wall screw #10 x 1-1/2” A A (H5) x 2 L-bracket C supplied B Just call 1-800-874-0008 for parts and service. For faster service, have the style number ready when calling.
STEP 1 (H2) 4x (H2) (H2) A (H2) (H2) x 4 hex screw B 1. Align top/ bottom panels (B) with side panel (A) as shown. 2. Secure each top/ bottom panel to the side panel using two hex screws. Use supplied hex wrench to tighten each screw.
STEP 2 (H1) (H1) B A C (H1) C B (H1) (H1) x 4 dowel 1. 2. 3. Arrange divider (C) as shown. Push two dowels into holes on both unfinished edges of divider. Align dowels on divider panel (C) with center holes on side panel (A). Push divider panel into place.
STEP 3 B 4x (H2) A (H2) C (H2) A B (H2) (H2) x 4 hex screw 8X (H2) 1. Align 2 dowels in divider (C) with dowel holes in side panel (A). Push to secure. 2. Secure side panel (A) to both top/ bottom panels (B) and divider panel (C) using four hex screws. Tighten screws using supplied hex wrench. 3. Use stickers to cover any exposed hardware.
STEP 4 WARNING All units MUST be fastened to the wall. top panel top panel (H4) (H3) wall stud wall stud (H3) x 2 L-bracket screw #10 x 1/2” (H4) x 2 wall screw #10 x 1-1/2” (H5) x 2 L-bracket 1. Align top of unit with wall stud. 2. Place screw hole end of L-bracket against wall/wall stud. Use 1-1/2” screw to secure L-bracket to wall. 3. Use 1/2” screw to secure L-bracket to top panel. L-bracket must be mounted no more than 1 1/2 inches from edge of panel.
