Instructions / Assembly

SET-UP
1. Begin in TEST mode by turning the TIME knob
to the TEST position, now the bulbs will activate in
daylight hours
2. Aim the sensor to the desired detection (target)
area. Have another person stand approximately in
the center of the target area moving arms up and
down or by walking left to right. The RED LED will
FLASH when a moving object is detected.
3. Slowly rotate the RANGE knob until the light
comes on. You may adjust the RANGE knob either
way to the desired sensitivity level (detection area).
4. Aim the unit higher for larger coverage or aim
downward for smaller spaces. This will most likely
take a couple of tries to determine your desired
trigger area. Look for the blinking RED LED to know
an object is being detected.
5. Once in the desired position tighten down the screw or ring on the motion sensor.
6. Now turn the TIME knob to adjust how long you want the lights to stay on after the
unit is activated. The maximum (full clockwise turn) is about 10 minutes. The minimum
(full counter-clockwise turn) is about 30 seconds.
0 ft. 17 ft. 45 ft. 70 ft.
17 ft. 45 ft. 70 ft.
8 ft.
0 ft.
SIDE VIEW FOR AIMING UNIT
TEST Mode Activates the photocell (dusk to dawn eye) and allows the motion sensor to function
in daylight hours so the xture can be set-up
TIME Mode Turn knob from 30 seconds to 10 minutes for desired ON time after the light xture
has been activated
RANGE Setting Mode Allows detection range to be adjusted to desired sensitivity
DOWN DETECT Expands downward detection and coverage area
LED Indicator 1. During the warm-up time the LED is on until the warm-up is complete
2. During TEST Mode, the LED is the indicator to show the user is in the detection
zone. When the sensor is triggered, the bulbs come on and the LED starts to ash.
When user is out of detection zone the LED stops ashing.
3.After the set-up is complete the LED is always on and ashing slowly to warn
intruders
Manual Override mode
(with wall switch)
Turn on the wall / light switch O-On twice within 2 seconds and the
bulbs will come on and stay on. After 6 hours, this option
automatically returns to TIME Mode.
Manual override to
return to TIME mode
(with wall switch)
During the light-on period (and in manual override mode) turn the wall switch
O-On once within 1 second and the xture will return to the TIME mode.
Temporary On Mode
(with wall switch)
Turn the wall switch O-On once within 1 second , the lights will come on to
support your immediate need (light on based on “Time” setting). Time will be
reset to extend the lights on.
Temporary On Mode
return to TIME mode
(with wall switch)
During the light-on period and in temporary ON mode, tum the
Lamp wall switch O-0n three times within 3 seconds
option will reset sensor to the TIME Mode.
Motion Sensor Control