Instructions / Assembly

ManualsBrandsDesigners Edge ManualsLighting300-Watt 270-Degree White Motion Activated Outdoor Dusk to Dawn Security Flood Light with Twin Head and Halogen Bulb

SET-UP

1. When the motion sensor has completed the “warm-up” process (approximately 90 seconds),

the sensor will automatically set to TEST mode and is ready to program. (SENS setting is in the

maximum range and the TIMER mode is OFF)

2 To make your selections push the touchpad and

the LED will move from left to right one position

at a time, the red LED will blink twice at the

selected position.

• Figure 1 shows all possible motion sensor function

settings.

3. Aim the sensor to the desired detection (target)

area. (Figure 2) Have another person stand

approximately in the center of the target area

moving arms up and down or by walking left to

right. The 4 red LEDs will chase back and forth

when a moving object is detected.

4. Push the SENS touchpad key to move the LED to

the position where you want to set the detection

range (MIN=minimum sensitivity; NORM=normal

sensitivity; BOOST=maximum).

5. Once in the desired position, tighten down the screw or ring on the motion sensor.

6. Now, push the TIME key to move the LED to the position (1, 5, or 20 MINUTES) to set the

detected TIMER Setting (Dusk to Dawn Control)

TEST Mode For initial set-up (Note: use the TIME touchpad key)

TIME Mode Push the touchpad key to choose 1, 5, or 20 minutes for desired ON time after

SENS setting Mode Adjustment for desired coverage area (select from minimum, normal, or boost)

DOWN DETECT Expands downward detection and coverage area

Timer Mode

Select from: OFF, 3Hours, 6Hours or Dusk to Dawn

LED Indicator

1.During the warm-up time the 4 LEDs are ON and chasing back and forth until the

warm-up is complete

2. During TEST Mode, the LEDs will chase to show the moving person is in the

detection zone. When the sensor is triggered, the bulbs come ON and the 4 LEDs

continue to chase back and forth. When the user is out of detection zone the LEDs

stop chasing.

3.After the set-up is complete the 4 LEDs chase back and forth to warn intruders

Manual Override mode

(with wall switch)

on and stay on. After 6 hours, this option automatically returns to TIME Mode

Manual override to

return to TIME mode

(with wall switch)

Temporary On Mode

(with wall switch)

your immediate need (light on based on “Time” setting). Time will be reset to extend

the lights on.

Temporary On Mode

return to TIME mode

(with wall switch)

During the light-on period and in temporary ON mode, tum the lamp wall switch

Motion Sensor Control

Figure 1