Instructions / Assembly

Note: The detection range specified above is based on the sensor’s performance in
conditions that represent average temperatures found in North America. The detection
range of the sensor will vary with changing ambient temperatures.
This fixture may be mounted on a wall or an eave. It may be mounted onto a
standard recessed outlet box or a wet location / outdoor outlet box. For easy
installation, replace an existing light fixture that is already connected to a wall switch.
WARNING: Maintain minimum 1.5” (3.8cm) distance between lampholders and sensor
head. Do not point lampholders directly at ceiling; possible fire hazard. Do not let lamps
touch ceiling. Keep a minimum 2” distance from ceiling.
TIPS FOR PROPER OPERATION
1. For optimal operation and optimal coverage area mount unit 6 to 8ft. above ground
on house overhang or wall.
2. Mount away from heat producing sources such as air conditioners & barbecue grills,
other light fixtures or sources of light. Keep in mind areas with traffic, pets or other
moving objects may cause nuisance triggering.
3. Do not aim at highly reflective surfaces such as smooth white walls, waterfalls, or
windows.
4. Point sensor slightly downward. Do not mount up facing sun.
5. If you are unfamiliar with electrical wiring, it is recommended you secure the services
of qualified electrician who can assure this installation meets national and local
electrical codes.
ASSEMBLY
If you already have outdoor lights in the location you intend to mount the new fixture,
you simply disconnect old fixture and remove. Follow steps for wiring the new units to
existing electrical box. If you do not have power to that location, a new outlet box and
wiring must be installed. DO NOT ATTEMPT TO DISASSEMBLE THE MOTION
SENSOR HEAD. THERE ARE NO USER SERVICEALE PARTS INSIDE. See
electrical wiring instructions for installation.
Remark: Fill in the wall plates and mounting surface with silicone.
CAUTION: Before beginning installation disconnect power to the location where the
light will be installed by shutting that controls the light is not sufficient to prevent