Instructions / Assembly

box is deep in the walls, too deep for included screws, you may obtain longer screws
from local hardware store. Make sure you match threads correctly.
8. Wiring portion is now complete, so you can install bulbs. Again, double check wall
switch is in off position and power is shut off at breaker.
OPERATION
SET-UP AND ADJUSTMENT
Follow these steps to set up your security light for best operation.
1. Turn power switch on and wait 60 seconds for the system’s circuitry to stabilize.
2. Turn the “Time” knob to the fully counter clockwise direction.
3. Turn the “Range” control all the way in a counter clockwise direction.
4. Aim the control module to the desired target area. Have a person stand
approximately in the center of the target area moving slightly. Moving arms up and
down is usually sufficient.
5. Slowly rotate the “Range” knob clockwise until the lights go on. You may adjust the
Test Mode
Activate the photocell and allow the motion detector to
function in daylight for time setting.
Auto Mode Turn knob from 30 seconds to 10 minutes as needed.
Manual Override
Mode
Turn the wall switch Off-On twice within 2 seconds, the
lights will come on and stay on. After 6 hours, this option
will automatically return to Auto Mode.
Manual Override to
return to Auto Mode
During the light-on period in manual override mode, turn
the wall switch Off-On once within 1 second, this option
will reset sensor to Auto Mode.
Temperary On Mode
Turn the wall switch Off-On once within 1 second, the
lights will come on to support users' immediate need(light
on based on "Time" setting). Time will be reset to extend
the lights on.
Temperary On to
return to Auto Mode
During the light-on period in temperary on mode, turn the
wall switch Off-On three times within 3 seconds, this
option will reset sensor to Auto Mode.
LED Indicator
1.During the warm-up time, LED is on until warm-up finish.
2.During Test Mode, LED is the indicator to show user in
the detection zone. When the sensor is triggered, the light
is on, and LED starts flash. When user is out of detection
zone, LED stops flash.
3.LED is always flash slowly to warn the intruder.