Instructions / Assembly
Installation Notes
1. Disconnect power before installation and when re-lamping.
2. If you are unfamiliar with installing electrical xtures contact a qualied
electrician to install
3. Securely fasten mounting bracket to the xture.
4. Do not attempt to relocate xture when hot.
5. Minimum distance from side wall is 5’
6. Keep out of reach of children.
Lamp Replacement
1. Disconnect power supply and make sure lamp and xture are not hot.
2. Unscrew the screws at the top of the housing.
3. Open hinged cover, remove the lamp by pushing one end into it’s
holder and pulling the other end towards you.
WARNING: Do not handle lamp with your bare hands as the oil from
your hands will cause premature failure of the lamp.
CAUTION, before using this appliance:
Check that the voltage indicated on the type plate
corresponds to the mains supply voltage.
• Ensure that the heater has been securely fastened
in its nal mounting position.
• Unplug and turn o power switch during
installation, cleaning and/or replacing the
emitter. Always ensure that the emitter is cool.
• Do not handle the halogen heat emitter with
bare hands.
• Do not use an extension cable with this product.
• Keep the power cable away from the body of the heater as it will get hot
during use.
• Ensure that children do not tamper with the heater.
• Do not insert any object through any slot or opening in the heater.
ENGLISH
H-12000_inst.indd 4 5/20/08 9:37:08 AM