Installation Guide

Figure 14

Figure 15

9. ATTACHING THE FAN

BLADES

Step 1 Fasten blade assembly to motor using the

screws supplied. (Fig. 14)

Step 2 Repeat for the two remaining blades.

10. INSTALLING THE

SWITCH HOUSING

NOTE: Before starting installation, disconnect the

power by turning off the circuit breaker or removing

the fuse at fuse box. Turning power off using the

fan switch is not sufficient to prevent electric shock.

1. Remove the screws from the mounting plate

under the fan motor.

2. While holding the switch housing under your fan,

snap together the wire connection plug. (Figure 15)

3. Raise the switch housing to the mounting plate

until the holes in switch housing and mounting

plate line up. Reinsert screws to secure in place.

(Figure 15)

Screws

Blades

Screws

Switch housing

Mounting plate

Connection plug