Installation Guide

9
Figure 17
12. INSTALLING THE
TRANSMITTER
HOLDER
Attach the remote control holder with the two
remote control holder mounting screws.
(Fig.17)
13. INSTALLING THE
BATTERY
Install the 12volt battery into the hand held
transmitter (Figure 18) as shown in (Figure 19).
Make sure the battery is secure with the matching
+/- terminals.
14. OPERATING YOUR
TRANSMITTER
Restore power to ceiling fan and test for
proper operation.
A. HI, MED and LOW buttons:
These three buttons are used to set the
fan speed as follows:
= high speed
= medium speed
= low speed
HI
MED
LOW
B. FAN OFF button:
This button turns the fan off.
C. LIGHT button:
This button controls the light. Press and
release the button to turn the light ON or
OFF. Press and hold the button to set the
desired brightness. The light key has an
auto-resume, it will stay at the same
brightness as the last time it was turned off.
Figure 18
Figure 19