Installation Guide

5
FIG.20
FIG.21
FIG.22
LIGHT KIT PLATE
LIGHT KIT PLATE
FIG.19
SCREW
GIASS
SCREW
BULB
REVERSE
SWITCH
Installing The Light Kit
Caution: Be careful not to touch
the glass area of the bulb, hold
with tissue during installation
as oil from your hands can cause
early lamp failure.
Fan Airflow Direction
2. Plug in the light wires from fan and the
light wires from light kit plate with pin
and plug . Place the light kit plate into
the bottom housing. (see Fig.18)
4. Plug the G9 Bulb into the socket (see
Fig.20)
3. I
nstall light kit plate using the three screws
and tighten them securely. (see Fig.19)
5. Carefully lift the glass shade up inside the
light fixture as far as it will go. Rotate the
shade in a clockwise (to the right) direction
until it is held tightly in place by the three
tabs (see Fig.21)
Slide the reverse switch to right or left to
obtain opposite direction of airflow. (see
Fig.22)
FIG.18
PIN AND PLUG
LIGHT KIT PLATE
1. Remove one screw and loosen the other
two screws from light kit adapter.(see
Fig.17)