(MODEL NUMBER:AC-19052)
SAFETY PRECAUTIONS WARNING-INSTALLATION SHOULD BE PERFORMED BY A QUALIFIED ELECTRICAN 1. To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly before beginning. 2. All electrical connections must be in accordance with local codes, ordinances or National Electrical Code. If you are unfamiliar with methods of installing electrical wiring secure the services of a qualified electrician. 3.
SCREW Install Blade Assembly BLADE Caution: To reduce the risk of personal injury. Do not bend the blade when installing, balancing or cleaning the fan . Do not insert foreign objects between rotating fan blades FIG.1 SCREW 1. Turn the fan body upside down with hanger bracket facing top. Place the blade on the hanger bracket and tighten the screws. (see Fig.1) 2.
Putting Your Fan Together HANGER BALL DOWNROD ASSEMBLY 1. Take off the washer, clevis pin and hairpin clip from the downrod. (see Fig.7) 2. Insert the downrod through the center opening in the canopy and route the motor leads though the hanger ball/downrod assembly. Align the clevis pin holes in the downrod with the holes in the motor coupling. The clevis pin must pass though the holes in the motor coupling and the downrod.
BLACK WIRE WHITE WIRE Wiring Your Ceiling Fan Caution: To avoid possible electrical shock,be sure electricity is turned off at the main fuse box before wiring. BLUE WIRE GREEN WIRE GREEN WIRE FIG.13 1. If you are not sure that electrical box is grounded,contact a licensed electrician for advice. It must be grounded for safe operation. 2. Connect the black wire from receiver to the black wire from fan with wire nut. Connect the white wire from receiver to the white wire from fan with wire nut.
Installing The Light Kit Caution: Be careful not to touch the glass area of the bulb, hold with tissue during installation as oil from your hands can cause early lamp failure. 1. Remove one screw and loosen the other two screws from light kit adapter.(see Fig.17) PIN AND PLUG LIGHT KIT PLATE FIG.18 LIGHT KIT PLATE 2. Plug in the light wires from fan and the light wires from light kit plate with pin and plug . Place the light kit plate into the bottom housing. (see Fig.18) FIG.19 SCREW SCREW 3.
Operation in Summer In warm weather, the reverse switch should be set to produce a downward flow of air. The constant, gentle breeze will transfer heat from your body; thus, you will feel cooler even if the temperature remains unchanged. This cooling effect is referred to as a wind-chill factor. In an airconditioned home, the wind-chill factor will allow you to set the thermostat higher than the usual setting. While using less energy to air-condition your home, you will stay just as cool.
7
8
