(MODEL NUMBER:AC-16752)
SAFETY PRECAUTIONS WARNING-INSTALLATION SHOULD BE PERFORMED BY A QUALIFIED ELECTRICAN 1. To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly before beginning. 2. All electrical connections must be in accordance with local codes, ordinances or National Electrical Code. If you are unfamiliar with methods of installing electrical wiring secure the services of a qualified electrician. 3.
Putting Your Fan Together 1. Insert the downrod through the center opening in the canopy and route the motor leads through the hanger ball/ downrod assembly. Align the clevis pin holes in the downrod with the holes in the motor coupling. The clevis pin must pass through the holes in the motor coupling and the downrod.
Wiring Your Ceiling Fan BLUE Caution : To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. BLACK BLACK WHITE GROUND 1. If you are not sure that the electrical box is grounded, contact a licensed electrician for advice. It must be grounded for safe operation. GROUND WHITE FIG.5 2. Connect the black wire from the outlet box to the black and blue wire from fan with wire nut.
The light pull chain has two positions. One pull turns the light on, two turns the light kit off. The fan pull chain has four positions. One pull is high, two is medium, three is low and four to turn it off. (see Fig.9) REVERSE SWITCH LIGHT PULL CHAIN FIG.
Operation in Summer In warm weather, the reverse switch should be set to produce a downward flow of air. The constant, gentle breeze will transfer heat from your body; thus, you will feel cooler even if the temperature remains unchanged. This cooling effect is referred to as a wind-chill factor. In an airconditioned home, the wind-chill factor will allow you to set the thermostat higher than the usual setting. While using less energy to air-condition your home, you will stay just as cool.
CARE OF YOUR FAN Here are some suggestions to help you maintain your fan. 1. Because of the fan's natural movement, some connections may become loose. Check the support connections, brackets, and blade attachments twice a year. Make sure they are secure. (It is not necessary to remove fan from ceiling.) 2. Clean your fan periodically to help maintain its new appearance over the years. Use only a soft brush or lint-free cloth to avoid scratching the finish.
TROUBLESHOOTING Problem Solution Fan will not start. 1. Check main and branch circuit fuses or breakers. 2. Check line wire connections to the fan and switch wire connections in the switch housing. 3. Check to make sure the dip switches from the transmitter and receiver are set to the same frequency. 1. Make sure all motor housing screws are snug. Fan sounds noisy. 2. Make sure the screws that attach the fan blade bracket to the motor hub are tight. 3.
