Installation Guide

Putting Your Fan Together
Hanging Your Ceiling Fan
1. Insert the downrod through the center
opening in the canopy and route the
motor leads through the hanger ball/
downrod assembly. Align the clevis pin
holes in the downrod with the holes in
the motor coupling. The clevis pin must
pass through the holes in the motor
coupling and the downrod. Place the
washer onto the clevis pin and install the
hairpin clip making sure to push straight
leg of the hairpin clip through the hole
near hanger ball to make sure the clevis
pin is properly installed (see Fig.1)
2. Remove the 2 set screws in the motor
coupling and securely tighten screws
against the downrod assembly.
Securely attach the hanger bracket to the
outlet box by washers and screws supplied
(see Fig.2)
1.
Carefully lift the fan and seat the downrod
and ball assembly on the hanger bracket.
Be sure the groove in the ball is lined up
with tab on the hanger bracket. (see Fig.
3)
2.
Install the safety cable into the building
structure (see Fig.4)
3.
FIG.2
FIG.3
FIG.4
FIG.1
CLEVIS
PIN
HAIR PIN
CLIP
COUPLING
SCREW
WASHER
CANOPY
HANGER
BALL
OUTLET
BOX
HANGER
BRACKET
WASHER
WASHER
HANGER
BRACKET
SAFETY
CABLE
SPRING
WASHER
HANGER
BRACKET
DOWNROD
DOWNROD
WASHER
SCREW
SCREW
2