Installation Guide

7
Figure 14
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
9. FINISHING THE
INSTALLATION
Step 1. Tuck connections neatly into ceiling outlet
box.
Step 2. Slide the canopy up to mounting bracket
and place the key hole on the canopy over the
screw on the mounting bracket, turn canopy until it
locks in place at the narrow section of the key
holes. (Fig.14)
Step 3. Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure by
tightening the two set screws. Note: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
Warning: Make sure tab at bottom of hanger
bracket is properly seated in groove of hanger ball
before attaching canopy to bracket. Failure to
properly seat tab in groove could cause damage to
electrical wiring.
10. INSTALLING THE
GLASS HOUSING
1. Install 4 x 15W candelabra bulbs (included).
2. Remove 1 of the 4 screws from the motor
housing and loosen the other 3 screws. (Do not
remove). Raise glass housing plate and glass
housing up against bottom of motor housing, place
the key holes from the glass housing plate over the
3 screws previously loosened , turn glass housing
plate until it locks in place at the narrow section of
the key holes. Secure by tightening the 3 screws
previously loosened and the one previously
removed. (Fig.15)
Figure 15
Glass
housing
Motor housing
Bulbs
Screws
Glass
housing
plate