Installation Guide

6
Step 3. (Figure 12) Receiver to House Supply Wires
Electrical Connections: Connect the black (hot)
wire from the ceiling to the black wire marked "AC
in L" from the receiver. Connect the white(neutral)
wire from the ceiling to the white wire marked "AC
in N" from the Receiver. Secure the wire
connections with the plastic wire nuts provided.
Step 4. (Figure 12) If your outlet box has a ground
wire (green or bare copper) connect it to the fan
ground wires; otherwise connect the hanging
bracket ground wire to the mounting bracket.
Secure the wire connection with a plastic nut
provided. After connecting the wires, spread them
apart so that the green and white wires are on one
side of the outlet box and black and blue wires are
on the other side. Carefully tuck the wire
connections up into the outlet box.
Note: Fan must be installed at a maximum distance
of 20 feet from the transmitting unit for proper signal
transmission between the transmitting unit and the
fan's receiving unit.
8. INSTALLING THE WALL
TRANSMITTER
WARNING! HOOK UP "IN SERIES" ONLY. DO
NOT CONNECT NEUTRAL SUPPLY WIRE OF
ELECTRIC CIRCUIT TO THE TRANSMITTER
WALL SWITCH, DAMAGE TO THE
TRANSMITTER WALL SWITCH AND POSSIBLE
FIRE COULD OCCUR.
Step 1. Remove the existing wall plate and switch
from the wall outlet box.
Step 2. Make the electrical connections as shown
in Fig.12. If your outlet box has a ground wire
(Green or Bare Copper) connect the Transmitter's
ground wire directly to one of the screws from the
outlet box. Secure all wire connections with the
plastic wire nuts provided.
Step 3. Carefully tuck the wire connections inside
the outlet box. Use the screws provided to secure
the wall transmitter and wall plate to the outlet box.
(Fig. 13)
Figure 12
Figure 13
White (neutral)
White (neutral)
Green or bare
copper (ground)
White ("AC IN N")
White ("to motor N")
Ground
(green)
(Connect to
ground wire on
hanger bracket
if no house
ground wire
exists.)
Outlet box
Black (hot)
Black ("AC IN L")
Black ("to motor L")
Blue ("to motor L")
Receiver
Blue (for bottom light)
Black (motor)
Orange (for upper light)
Orange (for upper light)