Installation Guide

5
6. INSTALLATION OF
SAFETY SUPPORT
An additional safety support is provided to prevent
the fan from falling. Secure the safety cable to the
ceiling joist with screw and washer, as illustrated in
Figure 9.
7. MAKE THE ELECTRIC
CONNECTIONS
WARNING: To avoid possible electrical shock, be
sure electricity is turned off at the main fuse box
before wiring.
NOTE: This remote control unit is equipped with 16
code combinations to prevent possible interference
from or to other remote units. The frequency
switches on your receiver and transmitter have
been preset at the factory. Please recheck to make
sure the switches on transmitter and receiver are
set to the same position, any combination of
settings will operate the fan as long as the
transmitter and receiver are set to the same
position.(Figure 10)
Step 1. (Figure 11) Insert the receiver into the
mounting bracket with the flat side of the receiver
facing the ceiling.
Step 2. (Figure 12) Motor to Receiver Electrical
Connections: Connect the Black wire from the fan
to Black wire marked "TO MOTOR L". Connect the
White wire from the fan to the White wire marked
"TO MOTOR N" from the receiver. Connect the
Blue wire from the fan to the Blue wire marked "For
bottom Light" from the receiver. Connect the Orange
wire from fan to the Orange wire from receiver
marked "For Upper Light". Secure wire connections
with the plastic wire nuts provided.
Hanger bracket
Safety cable
Figure 9
Figure 10
Figure 11
Code switch
ON
ON
Receiver
Hanger
bracket