Installation Guide

9
Figure 18
13. ATTACHING THE
GLASS SHADE
ASSEMBLY
NOTE: Before starting installation, disconnect the
power by turning off the circuit breaker or removing
the fuse at fuse box. Turning power off using the
fan switch is not sufficient to prevent electric shock.
Step 1. Install three 40W candelabra base bulbs
(included).
Step 2. Raise glass shade assembly up against
light plate. Place the 3 screws already installed
inside the glass shade over the key holes on light
plate at the wide section of the key holes. Turn
glass shade until the screws lock in place at the
narrow section of the key holes. (Fig. 18)
Glass shade
assembly
Light plate
Screws
Bulbs