Installation Guide

4
Installing the switch housing
1. Plug in the light wires from fan and the
light wires from light fixture (see FIG.
8).
2. Plug the halogen bulb into the sockets.
Do not touch the glass bulb with your
fingers. It is extremely important that
the glass be clean. If it is touched, or
dirty, clean carefully with a tissue. A
dirty glass bulb will cause the bulb to
fail almost immediately (see FIG 9).
3. Position the indentations in the outer rim
of the glass shade so that they line up
with the tabs on the inside surface of the
fan light fixture rim. Carefully lift the
glass shade up inside the light fixture as
far as it will go. Rotate the shade in a
clockwise direction until it is held
tightly in place by the three tabs (see
FIG 10).
Fan Airflow Direction
1. Slide the reverse switch to right or left
to obtain opposite direction of airflow
(see FIG 11).
SOCKET
BULB
TAB
FAN
INDENTATION
GLASS
FIG.9
FIG.8
COUPING
COVER
REVERSE
SWITCH
FIG.11
FIG.10
LIGHT
FIXTURE
PLUG
SCREW
FAN