Product Info
Table Of Contents
- 1.1 About this manual 2
- 1.2 Explanation of signal words and symbols 2
- 1.3 Customer service & service 3
- 2.1 Intended use 4
- 2.2 Warnings and occupational health and safety 4
- 2.3 Safety standards 5
- 5.1 Technical requirements 7
- 5.2 SQL database configuration 7
- 5.3 System software 7
- 8.1 Installation 12
- 9.1 Configuration at the factory 18
- 9.2 Retrofitting the IN and OUT devices with SMART MOVE 18
- 9.3 Decommissioning and disassembly 19
- 9.4 Disposal 19
- 1 General
- 2 Safety
- 3 Scope of delivery
- 4 SMART MOVE system
- 5 System requirements
- 6 Technical Data
- 7 Configuring beacons
- 8 Installing beacons in the lane
- 9 Configuring the IN and OUT devices
- 10 Version overview
Installing beacons in the lane 8
© DESIGNA Verkehrsleittechnik GmbH 17
DESIGNA SMART MOVE_Installation_110_ENG.docx
8.1.4 Connecting the beacon in the DCT casing body
Power supply
The beacon in the DCT is powered by two supplied batteries (2x 1.5 V
type Mono D).
Fig. 12: Power supply beacon in DCT - batteries
Insert the batteries into the holder on the mounting panel.
Connection
Fig. 13: Connection of beacon in DCT to battery
Plug the female connector onto the male connector of the beacon
(as shown above).