Instructions / Assembly

1 . 8 0 0 . 5 2 5 . 0 7 3 3
DESIGNTOSCANO.COM
FOR
YOUR
INSTRUCTIONS
PRODUCT
©Copyright 2017, Design Toscano, Inc.
FOR
YOUR
T H A N K YOU
P U R C H A SE
DW-35126
Glacier Peak Cascading Garden Fountain
Step 1
Slide cover on the
fountain body.
Step 2
Connect the flexible
hose to the pump.
Place pump inside
bottom of cavity.
Fill the reservoir with water
and take a note of the level that
the water reaches for future
reference when topping off.
Step 3
Step 4
Adjust the pump flow rate to achieve the desired
effect and to minimize any splashing. Splashing
can occur if the flow rate is too high or the feature
water level is too full. The flow rate can be increased
or decreased by moving the flow rate control slider
on the pump body. Moving the switch towards
(+) will increase the flow rate and moving it
towards (-) will decrease it.
WARNING:
Never turn on the pump before the fountain is full
of water. Also do not let the water level fall below
the top of the pump as the pump will become
damaged if ran without water. Fountain should
be placed on a level surface.
Thank you for your recent purchase
of this Design Toscano hand crafted
garden fountain. We have taken great
care to create this piece especially for
you. Please review these instructions
and assemble this piece with care.
Plug in and switch on.
After a short while the
water will start to flow.
Add water as needed.