MeshWorks® shelving Parts List Mesh Shelf (A) x4 Grid (B) Top Pole Section (C) x4 Bottom Pole Section (D) x4 Leveling Foot (E) x4 Threaded Insert (F) x4 Shelf Clip (G) 18 clips (36 pieces) Plastic Cap (H) x4 Utility Grid Hook (I) x5 ! Do not throw away packaging materials until assembly is complete. ! To clean, wipe with a soft, dry cloth. Spot clean with a damp cloth if needed. Scan here to watch the instructional video.
Step 1 Attach all 4 top pole sections (C) to all 4 bottom pole sections (D) using the threaded inserts (F). Screw a leveling foot (E) into the bottom of each pole. Bottom pole section (D) Bottom pole section (D) does not have groove. Leveling Foot (E) Pole (C & D) Assembly Step 2 Once poles are assembled, select the groove (spaced in 1” increments) where you’d like your lowest shelf to rest. Position the two halves of your shelf clip (G) so that the beveled edge is facing the top.
Step 3 Once the shelves are in place, attach shelf clips (G) at equal heights on the back poles where you'd like your grid to hang. Slide the grid down from the top of the back two poles. Tap gently from the top with a rubber mallet to secure, if needed. B G Step 4 Install clips and top shelf following the steps listed in Step 2. A G The designs, images, artwork, product descriptions and data shown in this document are protected by U.S.
Step 5 With the unit fully assembled, press a plastic cap (H) into the hole in the top of each pole. To level your assembled unit, adjust the feet by twisting to the desired height. Step 6 To add a Utility Grid Hook (I), hold the hook so that the widest part is at the bottom. Hook the short arm under the bottom wire where you'd like the hook to rest (1.), then tilt the hook towards the grid over a top wire (2.) and pull downward to secure (3.). 1. 2. 3.
