Installation Guide

FARMSTEAD FLUSH-MOUNT FIXTURE (Item #836213)
ASSEMBLY/INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need them at a later date.
CAUTION
WARNING: Risk of Fire. Min 90°C supply wires. If in doubt about electrical installation, consult a licensed electrician.
Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock.
GENERAL
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards.
If you are unfamiliar with proper electrical wiring connections obtain the services of a qualified electrician.
Remove the fixture and the mounting package from the box and make sure that no parts are missing
by referencing the illustrations on the installation instructions.
ASSEMBLY AND INSTALLATION
Turn off the power at fuse or circuit breaker
1. Gently take all parts out of the package, lay them on a smooth surface, and unscrew the MOUNTING SCREWS.
Attach the MOUNTING BAR to the OUTLET BOX using (2) MOUNTING SCREWS.
2. Install BULB with TYPE GU24 MAX. 18W wattage (not included).
3. Install the GLASS into IRON RING with salient point outside, and fix the IRON RING on the HOUSING using SCREWS.
4. Make wire connections with WIRE NUTS:
A-Connect the black wire from the Fixture to the black supply wires.
B-Connect the white wire from the Fixture to the white supply wires.
C-Attach the fixture ground wire to the MOUNTING BAR with the green screw. Then connect it to the supply
GREEN GROUND WIRE with the WIRE NUTS. Carefully tuck wires back into the OUTLET BOX.
5. Install FIXTURE SCREW through the CANOPY then screw onto the MOUNTING BAR using screwdriver.
Turn on the power at fuse or circuit breaker. Customer Service 1-800-558-8700
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
ITEM#836213