Installation Sheet

11″ CEILING LIGHT
ASSEMBLY/INSTALLATION INSTRUCTIONS
branch circuit conductor.
shock.
# 587519
# 587527
Customer Service 1-800-558-8700
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a
referencing the illustrations on the installation instructions.
CAUTION
GENERAL
ASSEMBLY AND INSTALLATION
ASSEMBLY AND INSTALLATION
(CONT.)
Please read carefully and save these instructions, as you may need them at a later date.
Turn off the power at fuse or circuit breaker.
Turn on the power at fuse or circuit breaker.
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
WIRE CONNECTOR
MOUNTING BRACKET
GROUND SCREW
MACHINE SCREWS
MOUNTING SCREWS
Item #587519/587527 : 11″ CEILING LIGHT
90
OUTLET BOX
GREEN GROUND SCREW
WHITE(NEUTRAL)
BLACK(HOT)
PAN
1. Attach the two screws to the MOUNTING BAR.
2. Attach the MOUNTING BAR to the OUTLET BOX with the
MACHINE SCREWS .
3. Pull out the supply wires and the SUPPLY GROUND WIRE from the OUTLET BOX. Make wire
connections using the WIRE CONNECTORS:
---Attach the FIXTURE GROUND WIRE to the MOUNTING BAR with the GREEN GROUND
SCREW.
Then connect it to the SUPPLY GROUND WIRE with the WIRE CONNECTOR.
Carefully tuck the wires back into the outlet box.
4. Attach the PAN to the MOUNTING BAR by inserting two MACHINE SCREWS and rotating the
PAN until it locks in place. Then tighten the SCREWS securely.
5. Screw the THREADED PIPE into the COUPLING, then secure it with HEX NUT A.
6. Install bulbs (not included). See relamping label at socket area or packaging for maximum
allowed wattage.
7. Attach the GLASS SHADE to the PAN by inserting over the THREADED PIPE. Secure it with a
HEX NUT B. Then carefully attach the CAP to the THREADED PIPE and secure it.
SOCKET
HEX NUT A
HEX NUT B
CAP
GLASS SHADE
THREADED PIPE