Instructions / Assembly

ManualsBrandsDesign House ManualsBathMiddleton 4 in. Centerset Single-Handle Bathroom Faucet in Oil Rubbed Bronze

o 584011 - Satin Nickel

o 584029 - Oil Rubbed Bronze

Problem: Faucet leaks from under handle.

Cause: Adjusting ring or cap assembly has loosened.

Action:

1. Move the handle to OFF position. Remove the

index, unscrew the screw and remove the handle.

2. Tighten the adjusting ring by turning it clockwise

with a small screwdriver. Move the ball stem to the

on position and continually tighten the adjusting ring

until the leak stops draining out from around the ball

stem.

3. If the leak does not stop, loosen the adjusting ring

and tighten the entire cap assembly by turning it

clockwise. Re-tighten the adjusting ring as before.

4. Reinstall the handle.

TROUBLE SHOOTING

Problem: Faucet leaks around aerator or an improper

flow pattern.

Cause: Aerator is incorrectly fitted or is dirty.

Action:

1. Unscrew the aerator. Make sure all internal parts

are laying flat.

2. If there is debris, gently flush all parts inside.

3. Reinstall the aerator.

Many of these parts come preassembled.

This exploded diagram is to assist in trouble

shooting.

POP-UP INSTALLATION PROCEDURE

Adjusting ring

Cap

Index

Handle

Set screw

Washer

Nut

Disc spring

Disc

Mixer ball

Cam

Cam packing

Aerator

Lift rod &

Lift rod knob

Screw

Strap

Clip

Washer

Pivot nut

Pivot Rod

& Ball

Body

Washer

Nut

Gasket

Washer

Flange

Stopper

4. Place one end of the spring clip (1)

onto the end of the horizontal rod (2).

Insert the horizontal rod (2) through a

hole on the strap (3). Connect the other

end of the spring clip (1) to the

horizontal rod (2). Insert the lift rod (4)

into the strap and tighten the screw (5).

2. Apply the silicone to the underside of the flange

(2). Insert the pop-up body (1) into the drain hole

from below sink. Screw the flange (2) into the pop-up

body (1). With the pivot hole (3) facing toward faucet,

use groove joint pliers to tighten the nut (4), do not

over tighten. Do not turn the pop-up while tightening

the nut, or sealant may not seal drain. Clean excess

putty. Apply thread sealant tape to the top threads of

the tailpiece (5) in a clockwise direction, as shown

and hand tighten.

3. Install the horizontal rod (2) and

the stopper (3) as shown (4). Hand

tighten the pivot nut (1).

1. Remove the stopper (1) and the flange (2). Screw

the brass nut (3) all the way down. Push the plastic

washer (4) and the gasket (5) down. Unscrew the

pivot nut (6) from the pop-up body (7) and remove

the seal washers (8). Take off the spring clip (9)

from the horizontal rod (10). Remove the tailpiece

(11) from the pop-up body (7).