Instructions / Assembly

ManualsBrandsDesign House ManualsLightingDane 1-Light Satin Nickel Wall Sconce

DANE 1LT WALL LIGHT

ASSEMBLY/INSTALLATION INSTRUCTIONS

Please read carefully and save these instructions, as you may need them at a later date.

CAUTION

Turn off the main power at the circuit breaker before installing the fixture, in order to prevent

possible shock

All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)

standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a

qualified electrician.

Remove the fixture an

the mountin

acka

e fro

the

ox an

make sure that no

arts are

GENERAL

missing by referencing the illustrations on the installation instructions.

ASSEMBLY AND INSTALLATION

TOOLS REQUIRED

Phillips Screwdriver.

Turn off the power at fuse or circuit breaker.

1. Before beginning the installation, carefully unpack and identify all parts.

2. Using (2) JUNCTION BOX SCREWS, securely fasten the CROSSBAR to the

JUNCTION BOX.

3. MAKE THE CONNECTIONS: Attach the FIXTURE GROUND WIRE to the

CROSS BAR with GREEN GROUND SCREW. Then connect it to the SUPPLY

GROUND WIRE with a wire nut. Using WIRE NUTS, connect the SUPPLY

WHITE WIRE(S) to the FIXTURE WHITE (or RIBBED) LEAD(S); Connect the

SUPPLY BLACK (or RED) WIRE to the FIXTURE BLACK (or SMOOTH)

LEAD(S). Wrap all connections with approved electrical tape.

LEAD(S).

Wrap

all

connections

with

approved

electrical

tape.

4. Place the WALL PLATE over the CROSS BAR and secure it with (2) LOCKING

NUTS.

5. Locate the GLASS SHADE and slide it over the SOCKET. Thread the SOCKET

RING onto the end of the SOCKET. Hand tighten until snug.

6. Install LIGHT BULB (Sold separately). Use 1 x 60W watt Max (Medium base)

bulb or energy saving equivalent DO NOT exceed the maximum wattage

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,

CONSULT A LICENSED ELECTRICIAN

#578815

bulb

energy

saving

equivalent

NOT

exceed

the

maximum

wattage

Turn on the power at fuse or circuit breaker.

Customer Service: 1-800-558-8700

CONSULT

LICENSED

ELECTRICIAN

Summary of content (1 pages)

PAGE 1
DANE 1LT WALL LIGHT ASSEMBLY/INSTALLATION INSTRUCTIONS Please read carefully and save these instructions, as you may need them at a later date. CAUTION Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock. GENERAL All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a qualified electrician.