Installation Sheet

ManualsBrandsDesign House ManualsIndoor LightingDesign House Perth Single Light 5-1/2" Wide Mini Pendant

PERTH MINI PENDANT SN SKU#578310

ASSEMBLY / INSTALLATION INSTRUCTIONS

Please read carefully and save these instructions, as you may need them at a later date.

CAUTION

Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock.

GENERAL

All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards.

If you are unfamiliar with proper electrical wiring connections obtain the services of a qualified

electrician. Remove the fixture and the mounting package from the box and make sure that no

parts are missing by referencing the illustrations on the installation instructions. Tools are

required when install this fixture.

REQUIRED TOOLS

Philips Screwdriver

ASSEMBLY AND INSTALLATION

Turn off the power at fuse or circuit breaker

1. Carefully unpack the fixture, lay out all parts on a clean surface.

2. Screw the TUBE D into the NIPPLE A, screw the TUBE C into the TUBE D, screw the TUBE B into the TUBE C, screw the TUBE A

into the TUBE B, screw the TUBE A into NIPPLE B from CANOPY.

3. Fasten the CROSS BAR onto the OUTLET BOX by using 2 OUTLET BOX SCREWS provided. Make sure the thread of the screw is

facing downward when the CROSS BAR is attached to the OUTLET BOX.

4. Tie the ground wire from the OUTLET BOX to the GROUND SCREW on the CROSS BAR.

Connect white wire from fixture to white wire (neutral wire) from supply circuit. Connect black wire from

fixture to black wire (live wire) from supply circuit. Cover connections using provided WIRE CONNECTORS.

5. Place the CANOPY to the OUTLET BOX by aligning the protruding MOUNTING SCREWS all the way through the CANOPY and

tighten the fixture using LOCK NUTS provided until fixture body is held firmly.

6. Unscrew the SOCKET RING and the CAP from the SOCKET, Place the SHADE over the SOCKET, refasten the CAP and the SOCKET RING to secure the SHADE firmly.

7. Install the BULB (Not included).

Turn on the power at fuse or circuit breaker.

Customer Service: 1-800-558-8700

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,

CONSULT A LICENSED ELECTRICIAN.

ITEM#578310

Summary of content (1 pages)

PAGE 1
PERTH MINI PENDANT SN SKU#578310 ASSEMBLY / INSTALLATION INSTRUCTIONS Please read carefully and save these instructions, as you may need them at a later date. CAUTION Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock. GENERAL All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a qualified electrician.