Installation Sheet

AUBREY WALL MOUNT LIGHTING FIXTURES
ASSEMBLY/INSTALLATION INSTRUCTIONS
NOTE: Fixtures are suitable for up or down mounting.
1. Before beginning the installation, carefully unpack and identify all parts
referring to Figure 1. Be sure the supply power is OFF.
2. Using 2 JUNCTION BOX SCREWS, securely fasten the CROSSBAR to the
JUNCTION BOX.
3. MAKE ELECTRICAL CONNECTIONS: (We recommend 2 people for
the remainder of installation) Connect the SUPPLY GROUND WIRE to the
FIXTURE GROUND WIRE with a wire connector and then secure it to the
CROSSBAR with GREEN GROUND SCREW. Using wire connectors,
connect the SUPPLY WHITE WIRE to the FIXTURE WHITE (or RIBBED)
LEAD(S); Connect the SUPPLY BLACK (or RED) WIRE to the FIXTURE
BLACK (or SMOOTH) LEAD. Wrap all connections with approved
electrical tape.
4. Place the WALL PLATE over the CROSSBAR; making sure the FIXTURE
SCREWS are through the holes on the WALL PLATE. Secure the FIXTURE
SCREWS with (2) LOCKING NUTS.
5. Place the GLASS SHADE over the SOCKET. Thread SOCKET RING onto
end of the SOCKET. Hand-tighten until snug.
6. Install LIGHT BULB (sold separately), referring to fixture labels for bulb
type and maximum wattage. The bulb quantities depend on the style
(See Figure 2).
7. Restore supply power (ON). Retain this sheet for future reference.
Customer Service: 1-800-558-8700
FIGURE 1
SOCKET
SOCKET RING
GLASS SHADE
LIGHT BULB
(Sold Separately)
FIGURE 2
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.