Installation Sheet

ManualsBrandsDesign House ManualsBathKarsen 8 in. Widespread 2-Handle High-Arc Bathroom Faucet in Satin Nickel

www.todaysdesignhouse.com

CARE AND MAINTENANCE

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION

Clean peridodically with a soft cloth.Avoid abraisive cleaners,steel wool, and harsh chemicals as these will dull

the finish and void your warranty

www.todaysdesignhouse.com

CARE AND MAINTENANCE

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION

Clean peridodically with a soft cloth.Avoid abraisive cleaners,steel wool, and harsh chemicals as these will dull

1. Move the handle to the OFF position. Unscrew the handle screw

and remove the handle.

2. Tighten the bonnet by turning it clockwise. Move the cartridge

stem to the on position. The leak should stop draining out from

around the cartridge stem.

3.Shut off the water supply. Remove the bonnet by turning it

counterclockwise. Lift out cartridge valve. Inspect the larger O-ring

on the cartridge bonnet and the smaller O-ring on the cartridge

stem.Remove any debris from the O-rings. If either O-ring is

twisted, straighten it out. If either O-ring is damaged, replace the

cartridge by calling customer service.

4.Position the cartridge back into the faucet body. Make sure the

ridges on the two sides of the cartridge bonnet fit into the grooves

on the two sides of the faucet body. Tightly screw the bonnet onto

the faucet body.

5.Re-install the handle.

Leaks

underneath

handle.

Bonnet has come loose

or O-ring on cartridge is

dirty or twisted.

Water does not

completely shut

off.

Rubber valve seat is

dirty,stuck, or broken.

1. Shut off the water supply to the faucet that leaks.

2. Remove the handle on the problem side. Loosen the bonnet by

turning it counterclockwise.Lift out the cartridge assembly.

3.Inspect the rubber valve seat in the faucet body. If there is debris

or brass scrap on the surface of the seat, remove it. If the rubber

seat is stuck tightly in the water inlet hole, push it gently with a

fingertip so that it moves up and down smoothly. The spring

(smaller end up) must be replaced underneath the valve seat. If

the rubber valve seat is worn out or broken, replace the cartridge

by calling customer service.

4.Replace the cartridge in the faucet body. Make sure that the

ridges on the two sides of the cartridge bonnet fit into the grooves

on the two sides of the faucet body. Tightly screw the bonnet onto

the faucet body.

5. Re-install the handle.