Installation Sheet

ManualsBrandsDesign House ManualsBathKarsen 8 in. Widespread 2-Handle High-Arc Bathroom Faucet in Satin Nickel

TWO HANDLE WIDE SPREAD

LAVATORY FAUCET WITH POP-UP

4-8-16

Design House is a registered brand

of DHI Corp.Mequon,WI 53092

1-800-558-8700

PREPARATION

SAFETY INFORMATION

Before beginning assembly of product, make sure all parts are present.

Compare parts with package contents list and hardware contents. If any

part is missing or damaged, do not attempt to assemble the product.

Contact customer service for replacement parts.

Estimated Assembly Time: 30 minutes

Tools Required for Assembly (not included): Adjustable Wrench, Groove

Joint Pliers, Pipe Wrench, Phillips Head Screwdriver, and Supply Lines.

Installations may vary depending on how the previous faucet was

installed. Supplies necessary for the installation of the faucet are not

all included; however, they are available wherever plumbing supplies

are sold.

Prior to beginning installation, turn off the hot and cold water lines, then

turn on the old faucet to release built-up pressure. When installing the

new faucet, hand tighten the connector nuts. DO NOT OVERTIGHTEN.

Connections that are too tight will reduce the integrity of the system.

Please read and understand this entire manual before attempting to

assemble, operate or install the product.

WARNING

• Protect your eyes with safety glasses when cutting or soldering water

supply lines.

CAUTION

• If you solder the joints during installation of the faucet, the seats,

or the warranty will be voided on these parts.

• Cover the sink drain to avoid losing parts.

www.todaysdesignhouse.com

PRODUCT SPECIFICATIONS

SPECIFICATIONS SPECIFICATIONS

1/4-turn ceramic cartridges

ASME A112.18.1/CSA B125

Manufactured to include no more than 0.25% weighted average lead

content on wetted surfaces

NSF 61-9

3-hole installation 6"-12" center distance

Chrome or satined nickel finish

NSF/ANSI 372

Notes: The picture in this installation instructions is for reference only, pls refer to

actual product in installation process.

MODELS

547653-Satined Nickel

547646-Polished Chrome

548289-Satined Nickel

548271-Polished Chrome

Summary of content (4 pages)

PAGE 1
Design House is a registered brand of DHI Corp.Mequon,WI 53092 1-800-558-8700 TWO HANDLE WIDE SPREAD LAVATORY FAUCET WITH POP-UP Notes: The picture in this installation instructions is for reference only, pls refer to actual product in installation process. MODELS 547653-Satined Nickel 547646-Polished Chrome 548289-Satined Nickel 548271-Polished Chrome NSF/ANSI 372 PRODUCT SPECIFICATIONS SPECIFICATIONS SPECIFICATIONS 1/4-turn ceramic cartridges ASME A112.18.
PAGE 2
.If it is running,
PAGE 3
CARE AND MAINTENANCE Clean peridodically with a soft cloth.Avoid abraisive cleaners,steel wool, and harsh chemicals as these will dull the finish and void your warranty TROUBLESHOOTING PROBLEM Leaks underneath handle. POSSIBLE CAUSE CORRECTIVE ACTION 1. Move the handle to the OFF position. Unscrew the handle screw Bonnet has come loose and remove the handle. or O-ring on cartridge is dirty or twisted. 2. Tighten the bonnet by turning it clockwise. Move the cartridge stem to the on position.
PAGE 4
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Faucet leaks around the aerator. Aerator incorrectly fitted. 1. Unscrew the aerator by turning it clockwise. Inspect the black rubber packing inside the aerator.The rubber packing should be flat. 2.Screw the aerator onto the spout end and tighten. Improper water Aerator dirty or small pattern. parts inside aerator improperly installed. 1. Remove the aerator from the spout end by turning it clockwise. 2.