Installation Guide

o 545673 - Polished Chrome
o 545665 - Satin Nickel
o 545657 - Oil Rubbed Bronze
3. Remove the pivot nut (1). Retain the
seal (2) on the horizontal rod (3). Install
the horizontal rod (3) and the stopper (4)
as shown (5). Hand tighten the pivot nut (1).
4. Attach the horizontal rod (1) to the strap
(2) using the clip (3). Insert the lift rod (4)
into the strap (2) and tighten the screw (5).
1. Remove the stopper (1) and the flange (2). Screw
the brass nut (3) all the way down. Push the plastic
washer (4) and the gasket (5) down. Unscrew the
tailpiece (6) from the pop-up body (7).
Problem: Faucet leaks from under handle.
Cause: Bonnet is loose or o-ring on cartridge is
dirty or twisted.
Action:
1. Move handle to OFF position. Remove the index
and unscrew the screw on handle, then remove the
handle and inverter.
2.Tighten the bonnet by turning it clockwise. Move
the cartridge stem to the ON position. The leak
should stop around the cartridge stem.
3. If the leak does not stop, shut off the water supply.
Remove the bonnet by turning it counter-clockwise.
Lift out the cartridge valve. Inspect the larger O-ring
on the cartridge bonnet and the smaller O-rings on
the cartridge stem. Remove any debris from the
O-rings. If either O-ring is twisted, straighten it out.
If either O-ring is damaged, replace the cartridge.
4. Replace the cartridge making sure the wings fit
well into the cuts in the faucet body. Tightly screw
the bonnet onto the faucet body.
5. Reinstall the handle.
Problem: Faucet leaks around aerator or an improper
flow pattern.
Cause: Aerator is incorrectly fitted or is dirty.
Action:
1. Unscrew the aerator. Make sure all internal parts
are laying flat.
2. If there is debris, gently flush all parts inside.
3. Reinstall the aerator.
Many of these parts come preassembled.
This exploded diagram is to assist in trouble
shooting.
2. Apply the silicone to the underside of the flange (2).
Insert the pop-up body (1) into the drain hole from below
sink. Screw the flange (2) into the pop-up body (1). With
the pivot hole (3) facing toward faucet, Use groove joint
pliers to tighten the nut (4), do not over tighten. Do not
turn the pop-up while tightening the nut, or sealant may
not seal drain. Clean excess putty. Apply thread sealant
tape to the top threads of the tailpiece (5) in a clockwise
direction, as shown and hand tighten.
Screw
Strap
Clip
Seal
Pivot nut
Horizontal rod
Pop-up
body
Washer
Nut
Gasket
Washer
Flange
Stopper
2
3
1
4
1
2
4
5
5
6
7
3
4
1
3
5
2
3
4
5
2
1
Tailpiece
Index
Screw
Handle
Bonnet
Inverter
Cartridge
Washer
Gasket
Mounting nut
Coupling nut
Lift rod &
Lift rod knob
Aerator