Installation Guide

POP-UP (OPTIONAL) INSTALLATION PROCEDURE
TROUBLE SHOOTING
POP-UP INSTALLATION
EXPLODED PARTS
Problem: Faucet leaks from under handle.
Cause: Bonnet is loose or o-ring on cartridge is
dirty or twisted.
Action:
1. Move handle to OFF position. Unscrew the set
screw on the side of the handle seat.
Then remove the entire handle assembly.
2. Tighten the bonnet by turning it clockwise.
Move the cartridge stem to the ON position.
The leak should stop around the cartridge
stem.
3. If the leak does not stop, shut off the water
supply.
Remove the bonnet by turning it counter
clockwise.
Lift out the cartridge valve. Inspect the o-rings.
Clear debris, untwist, or replace if necessary.
4. Replace the cartridge making sure the wings
fit well into the cuts in the faucet body.
Tightly screw the bonnet onto the faucet body.
5. Reinstall the handle.
Problem: Faucet leaks around aerator or an
improper flow pattern.
Cause: Aerator is incorrectly fitted or is dirty.
Action:
1. Unscrew the aerator. Make sure all internal
parts are laying flat.
2. If there is debris, gently flush all parts inside.
3. Reinstall aerator.
Many of these parts come preassembled.
This exploded diagram is to assist in trouble
shooting.
1. Remove stopper (1) and flange (2).
Screw nut (3) all the way down.
Push washer (4) and gasket (5) down.
Remove tailpiece (6) from body (7), add Teflon tape,
replace tailpiece.
2. Apply a small bead of Plumber's putty to underside
of flange (1).
Insert body (2) into sink.
Screw flange (1) into body (2).
Pivot (3) must face faucet.
Pull assembly down firmly and hold in place.
DO NOT TWIST.
Tighten nut, washer & gasket (4), clean off excess
Plumber's putty.
3. Remove pivot nut (1).
Install horizontal rod (2) and stopper (3)
as removable (4) or non-removable (5).
Hand tighten pivot nut (1).
4. Attach horizontal rod (1) to strap (2)
using clip (3).
Insert lift rod (4) into strap and tighten
screw (5).
21
3 4
④
⑤
⑦
③
⑥
②
①
④
③
②
①
⑤
④
③
②
①
⑤
③
②
①
④
Cartridge
Bonnet
Handle
Set Screw
Stopper
Flange
Washer
Gasket
Nut
Washer
Body
Pivot Rod & Ball
Pivot nut
Washer
Clip
Strap
Screw