Installation Guide

ManualsBrandsDesign House ManualsHanging LightsMillbridge 1-Light Oil Rubbed Bronze Mini Pendant

MINI PENDANT SERIES

ASSEMBLY/INSTALLATION INSTRUCTION

1. Before beginning the installation, carefully unpack and

identify all parts.

2. Turn the electrical power to the installation point OFF.

3. Carefully pull the wires through the STEMS into the

FIXTURE CANOPY as shown in Figure 1. Thread PIPE

NIPPLE into STEMS as shown. Attach as many of the stems

as desired to make the suitable height.

Note: Most of Mini Pendant provided with (4) stems

(6”+12”+12”+6”).The quantities and lengths of the stems

depend on the style you purchased.

. Attach first STEM to SWIVAL located at bottom of

CANOPY.

5. Attach the last STEM to FIXTURE SOCKET ASSEMBLY

and carefully pull excess wires through CANOPY.

6. Using (2) JUNCTION BOX SCREWS, securely fasten the

CROSSBAR to the JUNCTION box.

7.MAKE WIRE CONNECTIONS:

Position the FIXTURE

under the JUNCTION BOX, Connect the SUPPLY GROUND

WIRE to the FIXTURE GROUND WIRE. Secure both to the

CROSSBAR with GREEN GROUND SCREW. Using wire

Connectors, connect the SUPPLY WHITE WIRE(S) to the

FIXTURE WHITE(or RIBBED) LEAD(S); Connect the

SUPPLY BLACK (or RED) WIRE to the FIXTURE BLACK

(or SMOOTH) LEAD(S). Make sure that there are no

exposed wires and wrap all connections with approved

electrical tape.

8. Fit the heads of the FIXTURE SCREWS through the

KEYHOLE in FIXTURE CANOPY, Thread (2) LOCKING

NUTS onto the ends of F

IXTURE SCREWS. Hand tighten to

secure fixture to ceiling. Be sure that there are no trapped or

pinched wires.

9．

Locate GLASS SHADE and pass over the SOCKET.

Thread SOCKET RING onto end of the SOCKET. Hand

tighten until snug.

10. Install the BULB (Sold separately) referring to fixture

labels for maximum wattage.

11. Restore electrical power to installation point. Retain this

sheet for future reference.

FIXTURE CANOPY

LOCKING NUT

SWIVAL

STEM

PIPE NIPPLE

STEM

SOCKET

PIPE NIPPLE

FIXTURE SOCKET ASSEMBLY

NOTE:

1. When installing lamps, DO NOT EXCEED MAXIMUM

WATTAGE RATING.

2. Sketches are only for general reference.

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,

CONSULT A LICENSED ELECTRICIAN.