Installation Guide

JELLY JAR OUTDOOR DOWNLIGHT SKU#507806 & 505198 & 502179 & 500181 & 502195
ASSEMBLY / INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need them at a later date.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture, in order to prevent possible shock.
GENERAL
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.) standards.
If you are unfamiliar with proper electrical wiring connections obtain the services of a qualified electrician.
Remove the fixture and the mounting package from the box and make sure that no parts are missing by referencing
the illustrations on the installation instructions. Tools are required when install this fixture.
REQUIRED TOOLS
Philips screwdriver
ASSEMBLY AND INSTALLATION
Turn off the power at fuse or circuit breaker
1. Carefully unpack the fixture; lay out all parts on a clean surface.
2. Fasten the CROSS BAR onto the OUTLET BOX by using 2 OUTLET BOX SCREWS provided.
3. Tie ground wire from OUTLET BOX and from fixture to the GROUND SCREW on the CROSS BAR.
Connect white wire from fixture to white wire (neutral wire) from supply circuit. Connect black wire from
fixture to black wire (live wire) from supply circuit. Cover connections using provided WIRE CONNECTORS.
4. Place the WALL PLATE to the wall by aligning the MOUNTING SCREW all the way through the WALL PLATE
and tighten the WALL PLATE using provided 2 LOCK NUTS. Fasten the WALL PLATE until held firmly against the wall.
5. Install the bulb (Not included).
6. Place the GLASS SHADE into the fixture and fasten with THUMB SCREWS. Do not over-tighten.
7. Use silicone caulking to seal between wall canopy and wall. Leave bottom unsealed so moisture can drain out.
Turn on the power at fuse or circuit breaker.
ITEM#507806 & 505198 &
502179 & 500181 & 502195
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
Customer Service: 1-800-558-8700