Specification

CONTACT SUPPORT
PHONE: [phone]
EMAIL: [e-mail]
ADDRESS: 8715 Boston place, Rancho Cucamonga, CA. 91730
www.designelementusa.com
• Avoid using any type of rough cleaning material on top of the cabinet
nish.
• Use mild liquid soap and water-dampened soft cloth to remove stains from
the cabinet and to clean the countertop.
• For the glass part of the mirror, use ammonia-free cleaning products.
CARE AND CLEANING
• Please go through this entire instruction manual before making any
attempt to assemble, operate or install the product.
• During installation, handle the tempered glass countertop and sink with
optimum care. They might break if hit hard on a solid surface.
• Don’t start using the vanity right away. Wait for approximately 24 hours
after installation so that the silicon glue can dry.
• When scrubbing the cabinet while cleaning, make sure you do not remove
or scratch the nish.
SAFETY AND PRECAUTIONS
!
While turning around the double sink counter tops, always add
support from the centre for safety
!
While turning around the double sink counter tops, always add
support from the centre for safety
1.
2.
Attaching Counter Top To Cabinet
2. Place the counter top on top of the
cabinet.
1. Apply continuous stream of quality
silicon glue on top of the cabinet
contact area.
24h
1.
2.
3.
2. Position and place the vessel sink in a way that it ts in the cut out area on the countertop.
3. Do not use the sink instantly. Wait approximately for 24 hours for the Silicon glue to dry.
1. Add silicon glue to the porcelain vessel sinks. For round glass vessel sinks do not put glue.
Attaching Sink To Counter Top
1.
2.
3.
4.
Installing The Drain On The Sink
4. Now that the drain is installed, you can connect the trap onto the drain.
3. Tie up the rubber and metal mounting rings over the drain opening from beneath
the sink.
2. For only the overow sinks, make sure that the hole on the drain is aligned with
the overow hole on the sink.
1. After you have installed the sink and countertop on the cabinet, put the drain
assembly inside the hole in the sink and x it rmly.
12"or 16"
1.
2.
3.
4.
Hanging Mirror On The Wall
4. Hang the mirror on to the screws.
3. Insert the plastic plugs into the drilled holes. Insert screws into the plastic plugs.
Leave the screws at least 0.5” – 0.75” inches outside.
2. Find the studs on the wall. They are normally placed 12” to 16” apart from
each other. Drill two holes on the studs as per your previous measurement
1. Measure the distance between the screw holes at the back of the mirror.
WARRANTY
Design Element warrants cabinets, mirrors, nishes and ttings to be free
from defects in workmanship and materials under normal use and service
for a period of one (1) year.
Please report any damage or missing pieces of your vanity to us immedi-
ately. These things must be reported no later than 30 days from the date of
delivery.
PACKING LIST
• Pre-assembled cabinet
• Countertop
• 2 Sinks
• 2 Mirrors
• Mirror mounting screws
• Drain
• Instruction Manual
BACK
FRONT
55”
22”
36”
DEC350
COLLECTION: Designer’s Pick
DIMENSIONS: W 55” | D 22” | H 36”
SKU CODE:
INSTRUCTION MANUAL
DRAWER