Specification

CONTACT SUPPORT
PHONE: [phone]
EMAIL: [e-mail]
ADDRESS: 8715 Boston place, Rancho Cucamonga, CA. 91730
www.designelementusa.com
•Please go through this entire manual before attempting to assemble,
operate or install the product.
•During installation, handle the integrated countertop and sink with
optimum care.
•Do not use the vanity instantly after installation. Once you have applied
glue to attach the countertop and sink, wait for approximately 24 hours
to let it dry.
•Avoid extreme hot then cold water on the glass sinks and countertops, as
it might damage it.
•When scrubbing the cabinet, make sure you do not remove or scratch
the fnish.
SAFETY AND PRECAUTIONS
•Having your entire sink and countertop as one, non porous material, makes
it extremely easy to clean and maintain.
• Avoid using any type of rough cleaning material on top of the cabinet
nish.
• Use mild liquid soap and water-dampened soft cloth to remove stains from
the cabinet and to clean the countertop.
• For the glass part of the mirror, use ammonia-free cleaning products.
CARE AND CLEANING
!
While turning around the
double sink counter tops,
always add support from
the centre for safety
!
While turning around the
double sink counter tops,
always add support from
the centre for safety
24h
1.
2.
3.
2. Now place the integrated glass sink on the glued cabinet.
3. Do not use the sink instantly. Wait approximately for 24 hours for the Silicon glue to dry.
1. Apply continuous stream of quality silicon glue to the top of the cabinet where the integrated sink needs to be placed.
Attaching Counter Top To Cabinet
4. Now that the drain is installed, you can connect the trap onto the drain.
3. Tie up the rubber and metal mounting rings over the drain opening from beneath the sink.
2. For only the overow sinks, make sure that the hole on the drain is aligned with the overow hole on the sink.
1. After you have installed the sink and countertop on the cabinet, put the drain assembly inside the hole in the sink and x
it rmly.
Installing The Drain On The Sink
1.
2.
3.
4.
Hanging Mirror On The Wall
1. Measure the distance between the screw holes from the back of the mirror.
2. Find the studs on the wall. They are normally 12” to 16” apart from each other. Drill two holes on the studs as per your
measurement.
3. Insert the plastic plugs into the drilled holes. Insert screws into the plastic plugs. Leave the screws at least 0.5” – 0.75”
inches outside.
4. Hang the mirror on to the screws.
12"or 16"
PACKING LIST
• Pre-assembled cabinet
• Integrated sink countertop
• 2 Mirror
• Mirror mounting Screws
• Drain
• Instruction Manual
WARRANTY
Design Element warrants cabinets, mirrors, nishes and ttings to be free
from defects in workmanship and materials under normal use and service
for a period of one (1) year.
Please report any damage or missing pieces of your vanity to us immedi-
ately. These things must be reported no later than 30 days from the date of
delivery.
BACK
FRONT
DEC079A
COLLECTION: Designer’s Pick
DIMENSIONS: W 63” | D 20” | H 34 7/8”
SKU CODE:
INSTRUCTION MANUAL
DRAWER
5 3/8”
20”
15 5/8”
19 7/8”
59”
30 1/2”
63”
62 1/4”
16 1/8”
31 3/8”
34 7/8”
24 3/8”
14”
23 7/8”
11 3/8”
23 7/8”
10 5/8”