Installation Guide

V2.00 - Installation Instructions, Specifications and Project Plans are effective 9/6/2016 . This information is updated periodically
and should not be relied upon after 2 years from 9/6/2016 . Please visit OZCOBP.com to get current information.
Tool Required
3/8" Driver
Cap (finger tight)
OWT Timber Screw
for dimensional details, see Overview page
Project 330 (10x10) step 2
DIY Vineyard Pergola Base
square
post to
beam
ledge
measure beam width and1.
mark dimension as shown
with pencil and square.
install post to beam ledge2.
on mark.
repeat on adjacent side3.
repeat on all posts4.
post
pencil
beam
width