Owner's Manual

46 47

Remove the gas valve from the gas block by following the

removal steps on page 39.

Scrub off and wipe away any carbon from the gas valve and

gas piston.

Apply a light coating of CLP to the gas adjustment valve and

the large ring on the gas piston. (Fig. e-1)

e) Gas Valve

Fig. e-1

WARNING: Do not remove the rings from the gas

piston, it is unnecessary for maintenance or cleaning,

and will void the warranty if tampering is evident.

CLEAN

Remove the chute panel and ejection panel by following the steps

on pages 16-17.

Apply CLP to the insides of the chute panel and ejection panel,

then, with a wire brush, scrub the insides of the chute and ejection

panels.

Wipe down the chute and ejection panels with a rag until all

fouling is removed.

Apply CLP to both panels release tabs, and to the ejection panel

actuating joints. (Fig. f-1)

Reinstall the bolt carrier group, chute panel, and ejection panel.

f) Ejector Panel and Chute Panel (Assembled)

Fig. f-1

CLEAN