Owner's Manual
44 45
Disassemble the bolt carrier group by following the steps on
page 26.
1.
2.
3.
4.
With either a plastic or wire brush, scrub the bolt carrier, bolt
body, bolt guide pin, firing pin, and firing pin retainer, removing
any carbon or any fouling buildup.
Wipe down the bolt carrier group with a rag until all fouling
is removed.
c) Bolt Carrier Group (Disassembled)
Apply CLP to the the bolt carrier group (bolt head and bolt lugs,
extractor, bolt guide pin, bolt carrier, firing pin, firing pin lock),
and allow it to soak for a minute or so. (Fig. c-1)
Fig. c-1
Using a caliber-appropriate sized bore snake with CLP, clean
the bore of the rifle. It may take multiple passes to remove
bore fouling.
Run cleaning patches with CLP applied through the rifle barrel
until the patches come through clean. (Fig. d-1)
Re-apply CLP to the bolt carrier, bolt body, bolt guide pin, firing
pin, and firing pin lock, extractor cutout, bottom bolt carrier
guides, and spring guide. (Fig. c-1)
Reassemble the bolt carrier group following the steps on
page 28.
CLEAN
1.
2.
3.
4.
5.
5.
6.
d) Barrel Assembly
Scrub the chamber lugs and feed ramps with a wire brush and CLP.
Wipe the fouling out of the chamber lugs and off the feed
ramps with a rag.
Clean out the gas block with a wire brush, wipe clean with
a rag, apply light CLP. (Fig. d-1)
Fig. d-1
CLEAN