Owner's Manual

42 43

CLEAN

Separate the upper receiver from the lower receiver by

popping out the three (3) captured takedown pins. (Fig. a-1)

With a brush and CLP, scrub the magazine well, then wipe it

clean with a rag.

If the hammer and sear mechanisms are dirty, scrub them

lightly with a brush and wipe clean as best as possible. (Fig. a-2)

Apply a drop of CLP to the trigger sear.

Using canned air or a low-PSI air compressor, blow out the

lower receiver if there are signs of excess dust or fouling

buildup. Wipe clean with a rag and/or soft brush.

a) Receivers

Fig. a-1

Fig. a-2

Remove the bolt carrier group, ejector panel, and chute panel

by following the steps on page 24-25.

Apply CLP to the the bolt carrier group, both sides (bolt lugs,

extractor, bolt guide pin, bolt head, operation rod guide), and

allow it to soak for a minute or so.

With either a plastic or wire brush, scrub the bolt carrier and

bolt head, removing any carbon or any fouling buildup.

Wipe down the bolt carrier group with a rag until all fouling is

removed.

Apply CLP to the the collar, bolt lugs, the extractor cutout, bolt

guide pin, bottom bolt carrier guides, and spring guide.

(Fig. b-1)

b) Bolt Carrier Group (Assembled)

Fig. b-1

CLEAN