Owner's Manual

40 41

ADVANCED

Fig. d-2

Fig. d-1

d) Gas Block Reassembly

Install the piston into the gas block, pressing it to the rear-

most position. (Fig. d-1)

Install the gas valve in the front of the gas block with the firing

condition rib at the 12 o’clock position, then rotate it until the

detent clicks into the desired firing condition setting. (Fig. d-2)

Use a punch tool to depress the detent to allow initial rotation.

CLEANING AND MAINTENANCE

Comprehensive knowledge of how to service and handle

firearms is of great importance. Experience has shown that

most failures, which occur while operating a firearm, are due

to negligence in maintenance. Special attention must be paid

to cleaning, lubricating, and inspecting the rifle; this will de-

termine whether or not the rifle will function properly. In order

to maintain accuracy, the barrel must be maintained properly.

The receivers, bolt carrier group, and other moving parts of the

rifle must be kept clean and lightly lubricated to ensure proper

operation of the rifle.

GENERAL

Ensure the rifle is clear and safe by removing the magazine,

placing the rifle fire selector on “Safe” and cycling the rifle

multiple times to ensure a clear chamber, visually

inspecting the chamber to confirm.

Desert Tech recommends cleaning the barrel

when accuracy begins to deteriorate, using

bore cleaning foam and the properly sized

bore snake. Follow cleaner product

instructions when cleaning the barrel.

Desert Tech recommends cleaning the MDR

every 1000 rounds in clean environments.

Dependent upon environmental conditions,

cleaning more often may become necessary.

Note: When the rifle is purchased, or after it has

been stored for long periods of time, the rifle should

be cleaned before use.

FIELD CLEANING

CLEAN