Owner's Manual

36 37
ADVANCED DISASSEMBLY
a) Bolt Head Disassembly
1.
2.
3.
Place the bolt body on a solid surface and press down on
the extractor with your finger behind the rib, right above the
extractor pin. Using a 3/32 punch and mallet or brass hammer,
press the extractor pin out from the left to the right to remove
the pin and release the extractor assembly from the bolt body.
(Fig. a-1)
Separate the extractor spring assembly from the extractor by
pulling it off the extractor. (Fig a-2)
Separate the extractor bump stop by popping it out of the
extractor spring with your finger or a small pointed object if it’s
stuck. (Fig. a-3)
Fig. a-1
Fig. a-2
Fig. a-3
ADVANCED
6.
7.
To move the dot down or up, use the included screwdriver to turn the
top screw counter-clockwise or clockwise, respectively. (Fig. b-4)
After each zero adjustment, re-tighten the lock screws to ensure
no zero shift occurs during firing.
L
L
Fig. b-3
Fig. b-4
MRO