Owner's Manual

26 27

CONVERSION & DISASSEMBLY

b) Bolt Head Removal / Bolt Carrier

Group Disassembly

Use a pen or a 1/8 Punch, press the firing pin retaining

pin (FPRP) out of the bolt carrier group from the right to

the left. (Fig. b-1)

When swapping the bolt head during a caliber conversion,

ensure the bolt head caliber label on the extractor matches

the chambering of the conversion kit being installed. (Fig. c-1)

Follow the Bolt Head Installation / Bolt Carrier Group Reassem-

bly steps on page 28 for bolt head installation instructions. For

further bolt head disassembly, refer to Advanced Disassembly

on page 37.

Tilt the bolt carrier group upwards and drop the firing

pin out. (Fig. b-1)

Press and rotate the bolt head to the rear, then rotate the

bolt guide pin 90-degrees to remove; pull it up and out.

(Fig. b-2)

Pull the bolt head out from the bolt carrier. (Fig. b-2)

Fig. b-1

FPRP

Firing Pin

Fig. b-2

Fig. c-1

c) Bolt Head Swap