User's Manual

EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW)
Initialize each page: Page 8/15
The volume setting is only active during calling. When starting a new call, the volume will be
the same since the last adjustment; The Volume Key can go up and down, the volume goes up
and down without ‘steps’; The volume wheels returns to its original ‘middle’ position. This
volume setting is also the setting for when the ‘Headset’ is plugged in.
6 User Profiles
Speaker volume adjusting for RINGTONE and KEYTONE,
It can be adjusted to Normal, Loud, Mute profiles.
The User profile key on up step is normal profile ;
The User profile key on middle step is loud profile ;
The User profile key on down step is mute profile .
Vibrating alert is always switched on; This volume is also adjusted for the ‘Headset’ when the
headset is plug in, Ringtone and Key tone are played in the headset as well.
7 Ringtone setting
Can input the code to switch the ringtone 1 to 4
Ringtone1 : #78737627538#
Ringtone2 : #5646363#
Ringtone3 : #7925626#
Ringtone4 : #3669#
8 Call Incoming
When a call is incoming and the phone is not calling, the phone will play the ringtone (except the
phone is in DOWN MUTE MODE) and vibrate and the key light will be shown.
During a call, a second incoming call cannot be taken. (The caller will hear the tone of an
occupied line). The phone will not make a sound or beep;