User Manual Model：John’s 1 Brand：John’s Initialize each page: Page 1/15
EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) Contents 1. For Your Safety ............................................................................................................................... 3 2. Phone Feature.................................................................................................................................. 4 3. Keys and Part .................................................................................................................................. 5 4.
EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) 1. For Your Safety Please read these simple guidelines. Not following them may be dangerous or illegal。 Road safety comes first Do not use the phone hand-held while driving. If using the phone hand-held, park the vehicle before conversing. Switch off in aircraft Switch your phone off when on an aircraft. The aircraft’s systems may be affected by the phone signal. You are legally obliged to comply with this recommendation.
EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) interference All wireless phones may be susceptible to interference , which could affect performance。 Enhancements and batteries Use only approved enhancements and batteries. Do not connect incompatible products. use sensibly Use only in the normal position as explained in the produce documentation. Do not touch the antenna unnecessarily. Emergency calls Ensure the phone is switched on and in service. Enter the emergency number ,then press the call key.
EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) Earpiece Volume Key Number Key SIM card User profiles Key # Key * Key Power on/off lock Key C Key Talk Key MIC LCD 3.
EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) Dial a phone number and answers a call. Talk Key press it to clear the input number one by one; C Key ～ 0～9 Number Key In idle, press to dial numbers; Long press it to speed dial; In idle, press it to input “*”/ “+” / “P”/“W” * Key To iuput # ＃Key Press it to adjust the volume Volume Key Push it to switch user profiles. adjusted to Normal , Loud, Mute. User Profiles Key Push it to switch Power on/off.,or locked the keypad or unlock. Power on/off lock Key 4.
EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) 1 Power on/off/Key Lock The power switch can switch the phone to power on/off/key lock mode. When the phone is in key lock mode, all keys will be invalid except when a call is incoming the C key and Talk Key are valid, and the Volume wheel. 2 DIAL When a dialing key is pushed, the corresponding letter will be displayed in screen and a keytone will be played except when the phone is in Down Mute Mode.
EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) The volume setting is only active during calling. When starting a new call, the volume will be the same since the last adjustment; The Volume Key can go up and down, the volume goes up and down without ‘steps’; The volume wheels returns to its original ‘middle’ position. This volume setting is also the setting for when the ‘Headset’ is plugged in. 6 User Profiles Speaker volume adjusting for RINGTONE and KEYTONE, It can be adjusted to Normal, Loud, Mute profiles.
EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) An incoming call can be accepted by press Talk Key and rejected by C Key when the phone is not in calling. 9 During calling During a call, the calling or called numbers will be shown on the screen, scrolling from right to left if too many characters to display in the screen. 10 Other The phone cannot support SIM plug in/out when the phone is on. If the end user wants to change the SIM, the phone should be restart after plugging in the new SIM 4.
EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) No. Description 1.1 Basic screen with all standard showings 1.2 Number layout 1.3 Graphic Incoming number 2.1 Key locked standard showing 2.2 Key unlocked standard showing 2.3 Key locking 2 sec. 3.1 Battery full 3.2 Battery medium full 3.3 Battery medium 3.4 Battery medium low 3.5 Battery low 3.6 Battery empty, 5 minutes 4.1 No network 4.2 Weak network 4.3 Medium weak network 4.4 Medium network 4.
EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) 5.1 Start screen 1 5.2 Start screen 2 5.3 Start screen 3 5.4 Start screen 4 5.5 Start screen 5 5.6 Start screen 6 5.7 Start screen 7 5.8 Start screen 8 6.1 Enter PIN 6.2 Try again 6.3 Enter PUK 6.4 Welcome 6.5 Enter new PIN 6.6 Re-Enter new PIN 7.1 Charging screen 1 7.2 Charging screen 2 8.
9.1 Speed dial EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) under ‘0’ Speed dial under 9.7 Speed ‘3’ 9.2 dial under ‘0’ 9.8 Speeddial dial under 9.3 Speed ‘3’ under ‘1’ 9.9 Speed dial under 9.4 Speed dial ‘4’ under ‘1’ 9.1 Speed dial under 9.5 Speed dial 0 ‘4’ under ‘2’ 9.6 Speed dial 9.1 under Speed‘2’dial under 1 ‘5’ 9.1 Speed dial under 2 ‘5’ 9.1 Speed dial under 3 ‘6’ 9.1 Speed dial under 4 ‘6’ 9.1 Speed dial under 5 ‘7’ 9.1 Speed dial under 6 ‘7’ 9.1 Speed dial under 7 ‘8’ 9.1 Speed dial under 8 ‘8’ 9.
EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) Initialize each page: Page 13/15
EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) 12. Turning off 1 screen 1 12. Turning off 2 screen 2 12. Turning off 3 screen 3 12. Turning off 4 screen 4 12. Turning off 5 screen 5 12. Turning off 6 screen 6 12. Turning off 7 screen 7 12. Turning off 8 screen 8 12. Turning off 9 screen 9 12. Turning off 10 screen 10 12. Turning off 11 screen 11 1. Signatures By signing this agreement, FTS and Desay officially agree with the terms and conditions stated in this Software Spec.
EXHIBIT D: FTS PHONE SOFTWARE SPEC (SW) FCC ID: XJG-JOHNS1 FC C ID Label: Initialize each page: Page 15/15
RF Exposure Information: FCC RF Exposure requirements: The highest SAR value reported under this standard during product certification for use next to the body is 0.685 W/kg, next to the head is 1.170 W/kg. This transmitter must not be collocated or operating in conjunction with any other antenna or transmitter. This device complies with part 15 of the FCC rules.
