User Manual Part 1

16
DX-WBRDVD1/DX-WBRDVD1-CA
Using a wired network provides the best performance, because the attached devices
connect directly to the network and are not subject to radio frequency interference.
Notes:
• When plugging or unplugging the LAN cable, hold the plug portion of the cable. When
unplugging, do not pull on the LAN cable but unplug while pressing down on the lock.
• Do not connect a modular phone cable to the LAN port.
• Since there are various connection configurations, follow the specifications of your
telecommunication carrier or Internet service provider.
2 Press ENTER. The Settings menu opens.
3 Press or to select Network.
4 If the network connection is active, Link Up appears next to Link Status. If the
network connection is not active, Link Down appears next to Link Status. Press
ENTER.
5 Select IP Mode, then press ENTER.
6 Press or to select an IP mode. You can select:
• Dynamic—Uses DHCP to automatically obtain an IP address.
• Manual—Lets you manually configure network settings, such as IP address,
subnet mask, and gateway settings. If you select Manual, the following screen
opens. Enter the IP information here.
7 Press to go to the previous menu.
To make changes to your network connection, see “Changing the Network settings” on
page 39.
Network
Interface
Link Status
MAC Address
IP Mode
IP Address
Subnet Mask
Gateway
Primary DNS
Secondary DNS
Wired
Link Up
00:22:84:FB:C6:05
Dynamic
192.168.42.119
255.255.255.0
192.168.42.1
202.96.128.166
10.4.4 11
Settings
Language
Parental
System
Network
Display
Audio
BD Live
Please enter new IP Address
Valid range of each segment is 0 to 255
Curr ent value 111.11.11.11
New Value
OK Cancel
DX-WBRDVD1_11-0150_MAN_V1.fm Page 16 Monday, April 4, 2011 1:08 PM