DIRECT-VENT FIREPLACE OWNER'S OPERATION AND INSTALLATION MANUAL PENINSULA MODELS (V)DVF36 TPNA-A(-HA)/TPNPA-A/TPNEA-A/TPNPEA-A SEE-THRU MODELS (V)DVF36 TSTA-A(-HA)/TSTPA-A/TSTEA-A/TSTPEA-A

www.desatech.com
56131-F 25
4. Figure 47 shows the log set. Logs “A” have
the knot at the end of the log. Logs “B” have
the knot at the middle of the log. Twigs “C”
have the shape of a “Y”. Twigs “D” have the
shape of bent twigs. Twig “E” is a straight twig
which is placed across the top of Logs “B”.
5. Figure 48 shows the top view of the burner
and grate.
6. Place logs “A” as shown in Figure 49.
7. Place logs “B” as shown in Figure 50. Lift the
end of log “A” that will be propped up and place
log “B” under it. At the same time, the other
side of log “B” is placed over the other log “A”.
Repeat procedure for the other log “B”.
8. Take twigs “C” (shaped like a “Y”) and place
them as shown in Figure 51.
9. Take twigs “D” (bent twig) and place them
as shown in Figure 51.
10. Place twig “E” across the top of logs “B” a
shown in Figure 51.
11. When nished installing the logs, close the
glass door. Make certain safety door switch is
fully depressed by door frame before securing
four (4) spring loaded latches.
12. Replace the louvers in reverse order with the
grilles pointing in the down position.
-
-
vice, or maintenance can cause


additional information, consult
   

Open
Close
Figure 46 - Opening Door Latches
Figure 47 - Log Set (9 Pieces)
A
A
B
B
C
C
D
D
E
Left
Front
Right
Back
Figure 48 - Burner and Grate (Top View)
Left
Right
Back
Front
Figure 49 - Installing Logs “A” (Top View)
Left
Front
Right
Back
B
B
A
A
Figure 50 - Installing Logs “B ” (Top View)
Left
Right
Back Front
D
C
C
D
E
Figure 51 - Installing Twigs “C, D, E ”
(Top View)
INSTALLATION
Continued