Instructions / Assembly

www.dero.com | 1-888-337-6729
© 2015 Dero
Pour a 16” diameter by 36” deep concrete footing.
Place the Fixit in the footing centered and plumb.
Decide which position the pump will be installed
and hold it in place while marking where the
anchor will go in the concrete. Drill a 3/8” x 3”
hole in the concrete with a hammer drill and
masonry bit. Clean up all concrete dust from
drilling. Hammer in the wedge anchor with an
inch of threads exposed above the concrete.
Place (2) 3/8” washers over the exposed
wedge anchor threads and then place the
pump mounting flange over the wedge anchor.
Secure with a 3/8” washer and nut. Then
secure the upper pump mount to the Fixit with
a 3/8” x ¾” carriage bolt, washer, and tamper-
proof nut.
The surface of the concrete to the hole on the
side of the Fixit should be 13.25”. Support the
Fixit and let the concrete set.
1
3 4
2
FIXIT
Installation Instructions – In Ground Mount
13.5”