Instructions / Assembly

RECOMMENDED BASE MATERIAL
Solid concrete is the best base material for installation. To ensure
the proper anchors are shipped with your rack, ask your Dero Rack
representative which anchor is appropriate for your application.
Be sure nothing is underneath the base material that could be
damaged by drilling.
www.dero.com | 1-888-337-6729
© 2015 Dero
Reference the Fixit setback recommendations
and place the upright in the desired location. Use
the base as a template and drill (4) 3/8” x 3” holes
in the concrete with a hammer drill and masonry
bit. Clean up all concrete dust from drilling.
Decide which position the pump will be installed
in and place the bottom pump flange over the
corresponding wedge anchor. Attach the top
pump flange to the Fixit upright with a carriage
bolt, washer, and tamper-proof nut. Tighten all
wedge anchors with washers and nuts.
Insert the tool cables into the cable slot on the
Fixit upright.
Hammer in the (4) wedge anchors. Leave at
least 3/4” of an inch of exposed threads above
the Fixit base.
1
3 4
2
FIXIT
Installation Instructions – Surface Mount
TOOLS NEEDED
Hammer drill
3/8” masonry bit
Hammer
Socket Wrench
9/16” socket
Tamper-proof socket (included)*
Socket extension, 6” min.
*Keep tool for future maintenance